How do you add dependent voltage source in pspice?

Note that the right side of the device goes where the voltage source appears in the circuit. The left side is connected so that the controlling current (in this case I0) runs through the left side of the dependent source symbol. After the dependent source has been placed, left click on it to select it.

How does a voltage-controlled current source work?

In a voltage-controlled current source circuit, as the name implies, a small amount of voltage across the input will proportionally control the current flow across the output loads. This type of circuit is commonly used in electronics to drive current-controlled devices like BJT, SCR, etc.

What is G in pspice?

G Device – Value Form. H. Current-Controlled Voltage Source. HPOLY. Current-Controlled Voltage Source.

What is voltage-controlled voltage source?

Voltage-controlled voltage source (VCVS)Edit This is a voltage source whose value is controlled by another voltage elsewhere in the circuit. Its output will typically be given as. , where A is a gain term and Vcis a control voltage.

What happens to dependent source in Thevenin Theorem?

Thevenin’s theorem can be applied when analyzing a circuit with dependent sources. In this case, all independent sources are turned off and the RTh is calculated by applying a current source or voltage source at the open terminal. If RTh takes a negative value, it means the circuit is supplying power to the terminals.

Is it possible to have a voltage dependent current source?

In the theory of electrical networks, a dependent source is a voltage source or a current source whose value depends on a voltage or current elsewhere in the network. An operational amplifier can be described as a voltage source dependent on the differential input voltage between its input terminals.

Which is a dependent source of PSpice voltage?

not present Dependent Source Abbreviation PSPICE Name Voltage Controlled Voltage Source VCVS E Current Controlled Current Source CCCS F Voltage Controlled Current Source VCCS G Current Controlled Voltage Source CCVS H

Where does the current go in a PSPICE circuit?

PSPICE Schematic with Current Controlled Voltage Source Note that the right side of the device goes where the voltage source appears in the circuit. The left side is connected so that the controlling current (in this case I 0 ) runs through the left side of the dependent source symbol.

How to calculate the voltage and resistance of Thevenin?

Unfortunately, calculating the Thevenin voltage and resistance can become difficult as circuit complexity increases. Figure 1, Figure 2, and Figure 3 illustrate a simple method for obtaining the Thevenin voltage and resistance—and, subsequently, the Norton equivalence—with the aid of simulation.

Why are Thevenin and Norton equivalent circuits important?

Thevenin- and Norton-equivalent circuits, among the most fundamental circuit-analysis theorems, can be useful for determining a load resistance for maximum power transfer, simplifying circuit models, and a variety of other analysis techniques.