How do I fix code P1345?

Loose the distributor hold down bolt with engine OFF. Make sure your OBD scanner is plugged in to monitor the Cam Retard Offset reading. Turn the engine on, let it warm to normal operating temps, and get the rpm’s above 1,000. If your reading is negative, turn the distributor counterclockwise.

What does P1345 code mean?

Error Code P1345 is defined as Crankshaft Position-Camshaft Position Correlation. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Audi, GM (Chevrolet/GMC), Isuzu, Lexus, Mazda, Toyota, and Volkswagen.

How much does it cost to replace a camshaft position sensor?

What is the typical cost for Camshaft Position Sensor Replacement? In most case, this is not a expensive repair. The sensor will cost somewhere between $50 and $100 depending on the manufacturer. Installation can vary depending upon the car, and will run from $40 to $200 depending upon the location.

What is the cost to replace a crankshaft sensor?

The average cost for a Crankshaft Position Sensor Replacement is between $178 and $226 but can vary from car to car.

What does the p1345 code on a Chevy mean?

If a P0016 or P1345 is resetting without any engine performance concerns but the above information did not isolate a cause for the DTC, replace the Cam Phaser Actuator sprocket. The cost to diagnose the P1345 CHEVROLET code is 1.0 hour of labor.

What are the symptoms of a fault code p1340?

Please can someone (hopefully) confirm that this P1340 error is a coil or plug issue. The symptoms are – Turning key to start engine there is a delay and struggle like when a battery is nearly flat. Sitting at idle the car starts to judder about (engine ticking over badly and shaking in the engine bay).

What kind of code reader got code p1445?

Hooked car up to launch 431 code reader got p1445 purge flow sensor circuit high input. pa435 a/c ref temp circuit range/performance no contact.

What does p1340 mean on a Peugeot 208?

I decided to search these forums and saw a couple of threads claiming that P1340 means something different on pugs/ 208s and is actually a ‘cylinder 4 misfire’ error.