How do I take apart my Admiral washing machine?

How to Open the Inside of an Admiral Top Loading Washing Machine

1. Unplug the power cord from the wall outlet.
2. Remove the two screws on the rear portion of the bottom of the control panel.
3. Pull the control panel forward slightly, then lift the control panel to flip it upside down and off of the washer.

How do I clean my Admiral washing machine?

No tools are needed.

1. Wash any laundry in the appliance and wait for the Admiral to empty all water after completing a cycle.
2. Hold the agitator column in one hand while unscrewing the cap on top of the agitator with your other hand.
3. Rinse the filter in a sink under cold water and wipe with a cloth.

How do I remove the agitator from Admiral washing machine?

Insert a flathead screwdriver along the edge of the agitator cap and the agitator. Twist the screwdriver to pop the cap from the top of the agitator. Reach inside the agitator to grab the plastic dust cap with your fingers and lift it from the agitator.

Why is my admiral washer not spinning?

Common solutions for: Admiral Washer won’t spin or agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. The lid switch assembly prevents the washer from spinning when the lid is open.

How do you fix a washing machine that is off balance?

It not only results in poorly washed clothing, but it often throws the washer out of balance when it reaches the spin cycle. The only real fix for this is to stop the washer during the spin cycle and redistribute the clothing for more balance. You may even wish to remove some items for the room.

How do you fix an out of balance washing machine?

Level the Machine A carpeted surface can throw this balance off. If your washer is located on a pedestal, the problem can be amplified. Top-loading washers automatically adjust to level. If something has shifted, you can relevel a top-loading washer by tipping the washer forward, then placing it back on the floor.

Are Admiral washing machines good?

basically, it’s been reliable, holds a good amount of clothes, and cleans them well. It spins them out well for the type of machine it is, but your laundry is going to be wetter out of one of these than a new high-efficiency machine. The machine is a very basic machine.

How do I put fabric softener in my Admiral washing machine?

Softener is added automatically during the rinse portion of the cycle. Dilute liquid fabric softener by filling the dispenser with warm water until liquid reaches the underside of the rim.

How do I reset my Admiral washing machine?

Turn the control dial to the normal cycle and restart the washing machine. The washing machine may pause for a moment, which is normal. Wait 1 minute. The washing machine should start again and agitate normally.

Where is the lid switch on an admiral washing machine?

Look for the lid lock switch on the underside of the top panel and where it fits into the appliance. Put the lid back down and plug the washing machine back into the electrical outlet.

What makes an admiral washer a good washer?

Admiral washers are built with sturdy parts that provide the powerful cleaning action needed to remove tough stains from your clothes. These washers also feature easy-to-use controls that let you to select the right settings for various wash loads.

What to do if your Sears Admiral washer won’t run?

When your Admiral washer won’t run or it stops draining, you’ll likely need some replacement parts to repair the washer. Trust Sears PartsDirect to have the Admiral parts you need to fix any washer failure. After the wash cycle ends and before the spin cycle starts, the water should drain from the washer.

What does the timer do on an admiral washer?

The timer controls the component functions in your washing machine. Also called a cycle selector, the timer has a motor that advances the internal cams inside the timer body. The cams open and close electrical contacts to energize and de-energize components during the wash cycle.

How big is the belt on an admiral washer?

This V-style drive belt measures 51 inches long and 3/8 inches wide. The belt is made to slip on the motor pulley to bring the basket up to the speed required. Continued use can result in the belt suffering from wear and tear.