How do I reset my HP PSC 1315 all in one printer?

How to Reset the HP PSC 1315

1. Turn on the PSC 1315 by pressing the “On/Resume” button until it lights up.
2. Remove the power cord from the back of the printer.
3. Press the power cord back onto the metal plugs located on the back of the printer.
4. Press the “On/Resume” button on the printer’s control panel until it lights up.

How do I free my ink cartridge cradle?

Easy to follow steps to fix the hp printer cartridge stuck right side

1. Just turn the all-in one-off and on again.
2. Clean any of the paper jam.
3. Make sure that the print carriage can move freely.
4. Remove the print cartridges.
5. Just reinstall the print cartridges.
6. Make sure the control- panel faceplate is correctly installed.

How do I manually change the ink cartridge in my HP printer?

Insert your hand into the Ink Cartridge Access Area and then move the Carriage manually. Move the Carriage to the left side if it’s stuck on the right, and vice versa. Also, move the Carriage to the right if it’s held in the center.

Can you take an ink cartridge out and put it back in?

If you remove a low or expended ink cartridge, you cannot re-install and use the cartridge. Caution: If you remove an ink cartridge for later use, protect the ink supply area from dirt and dust and store it in the same environment as the printer.

What causes carriage stall on hp PSC 2355 printer?

Close the print cartridge access door and plug the power cord back to the back of the product. Plug the power cord into the power source. Press the On button to turn on the product. If the error message is not resolved, continue to the next step. Improper placement or installation of the print cartridges can cause a carriage stall error condition.

How to get rid of carriage on HP printer?

With the product turned on, open the print cartridge access door. The print carriage might try to move into the access area. If so, allow it to move to that position. Without turning off the product, unplug the power cord from the back of the product. Unplug the power cord from the power source.

Why is the carriage on the right side of my HP printer?

The carriage would not move to the center when the cartridge door was opened. I read a lot of forum entries and found one that recommended unplugging power cord from back of printer and waiting 60 seconds. Then hold down #6 while plugging power cord back in. Hold #6 down until printer restarts and then release.

What to do if your printer carriage won’t move?

Try to gently manually move the print carriage from one side to the other. If the carriage is at the right side, it is docked in its station. You can try to lift up and slide it to the center. I would recommend to call HP Tech Support for further assistance to see what other options are available for you. Contact HP Worldwide.