How to reset d-Link DP 300U print server?
How to reset an inaccessible D-Link DP-300U print server?
- Try accessing it via its default IP address 192.168. 0.10.
- Look into the protocol of your DHCP server to find out about its IP address.
- Try listing the device using the “Discover” function in PS Admin 3.0.
- For the default password of the web interface, see here.
How do I reset my Dlink print server?
D-Link Blog Home Step 1: Locate the hole on the back of the print server above the word RESET. Step 2: Using a paper clip, press and hold the Reset button for about 5 seconds and then release. Step 3: After the print server reboots it will be reset to the factory default settings.
What does the D-Link dp-300u print server do?
The D- Link DP-300U is a compact print server that connects to your Ethernet or Fast Ethernet network. With high-speed ports, DP-300U allow users to print simultaneously from anywhere on the network.
Is there any way to factory reset Dlink DP-301P +?
Get answers from your peers along with millions of IT pros who visit Spiceworks. Hi all, I have a d-link print server, it seem like faulty, I’m not able to ping it and go into web-base to do any configuration. Is it any way that I can do factory reset to test it? Where do you stack up against other IT pros? Take the Challenge »
Is there a D-Link print server reset button?
The solution is simple. This also on other D-link print server models, if you did this on models that are not listed below, please leave a comment so i can add them. The D-link Dp-101 is a stable parallel to network print server, but it does not have the feature of a “Reset to default settings” hardware button anywhere.
How do you connect a dp-300u RJ-45 printer?
Connect the DP-300U RJ-45 Connector to the network, using an Ethernet CAT5 cable. 4. While each printer is powered OFF, install the corresponding parallel or USB printer cable to connect the printer™s parallel port or USB port to the printer port of the Print Server. 5. 6. Switch on each connected printer.