Which command set a trunk port on a 2960 switch?

Solution(By Examveda Team) To set a switch port to trunk mode, which allows all VLAN information to pass down the link, use the switchport mode trunk command.

What is a trunk port configure for?

Ethernet interfaces can be configured either as access ports or trunk ports. Trunks carry the traffic of multiple VLANs over a single link and allow you to extend VLANs across the network.

How do you check a trunk port on a switch?

Use the show interfaces trunk command to check whether the local and peer native VLANs match. If the native VLAN does not match on both sides, VLAN leaking occurs. Use the show interfaces trunk command to check whether a trunk has been established between switches.

What is the difference between an access port and a trunk port?

An access port is a connection on a switch that transmits data to and from a specific VLAN. A trunk port allows you to send all those signals for each switch or router across a single trunk link. In contrast to an access port, a trunk port must use tagging in order to allow signals to get to the correct endpoint.

Can a trunk port connect to an access port?

The trunk port basically used to connect between switches; however, the access port is used to connect computer laptops, printers, etc. We cannot extend the data from one switch to another switch, access ports via a trunk port. It can only be extended via the access port of the switch.

Can we connect trunk port to access port?

How do I remove a VLAN from a trunk port?

Remove VLANs from a vPC

1. Log in to the Cisco Nexus series switch.
2. To run the configuration, type: Switch-A# config terminal.
3. Type: Switch-A(config)# interface port-channel port_channel_number.
4. To delete the VLAN ID, type: Switch-A(config-if)# switchport trunk allowed vlan remove VLAN_IDs.

What is the purpose of a Cisco 2960?

They operate on Cisco IOS ® Software and support simple device management as well as network management. The Cisco Catalyst 2960-X and 2960-XR Series provide easy device onboarding, configuration, monitoring, and troubleshooting.

How many VLAN create in Cisco switch?

The Cisco Catalyst 3550 switches support up to 1,005 VLANs. The Cisco Cataylst 3750 switches support up to 1,005 VLANs per stack. Both support up to 4000 VLAN IDs, but only 1,005 VLANs configured on these (some VLAN IDs will come from other switches).

Does Cisco 2960x support WCCP?

According to the Cisco website, Cisco 2960X WS-C2960X-48TD-L doesn’t support WCCP, but 2960XR with IP base or IP services license does.

What are the ports on Cisco Catalyst switches?

This section describes the front panel components of an 8-port and 16-port Cisco Catalyst 1000 switch. 8 or 16 downlink Ethernet ports of one of these types: 10/100/1000 . 10/100/1000 PoE+ . 2 SFP module ports . RJ-45 console port . USB mini-Type B (console) port . USB Type A port . LEDs . Reset button. Figure 1. Front Panel of an 8-Port Cisco

https://www.youtube.com/watch?v=tDQ682bsEOY